Tuningfan Shift Pattern Upper Left for Manual Transmission ND5RC ZN6 Emblem, Reverse, 6-Speed Vehicles, SPE-A601

Tuningfan Shift Pattern Emblem - Upper Left R (for 6-speed manual transmission vehicles) Hairline base finish + clear dome coating Made with non-yellowing polyurethane resin. Adhesive: Strong adhesive. Size: 16mm (height) x 22mm (width) x approximately 2mm (thickness) Made in Japan Tuningfan Shift Pattern Emblem - Upper Left R (for 6-speed manual transmission vehicles) Part number: SPE-A601 Using a dome made of highly transparent polyurethane resin It combines a three-dimensional, beautiful gloss with high durability thanks to UV protection. Unlike typical stickers, these offer a premium finish that upgrades your interior. This applies to all 6-speed manual transmission vehicles with the same pattern as indicated. It can be installed simply by attaching it to the side of the shift boot or the shift panel. The dimensions are 16mm in height and 22mm in width. To allow for placement in various locations, the dimensions are almost identical to those of the original shift pattern labels from car manufacturers. The size is set to be not too large. A simple and timeless design that eliminates unnecessary logos and decorations. Tuningfan Original Product *Shift knobs without a shift pattern printed on them will not pass vehicle inspection. Recommended for those with aftermarket shift knobs that do not have a pattern plate installed. The adhesive in this product is made from the strongest possible material, If there is dust or oil on the surface to which you are applying the sticker, the adhesive strength will inevitably decrease significantly. If a polishing agent or similar has been applied, Please remove any residue thoroughly using a parts cleaner or alcohol wipe before applying. After peeling it off the separator (backing), carefully stick it on, making sure not to touch the adhesive surface. Apply pressure to the entire surface and press firmly to ensure a tight fit. It can take up to 24 hours for the adhesive to stabilize after initial adhesion. Please avoid moving or repositioning it. If the temperature is below 10 degrees Celsius, it will be difficult to apply, so use a hairdryer or similar device. Please warm it slightly before applying. Flat/gently curved surfaces made of common plastics (PE, PP) This product is designed to be attached to interior panels. For application to rough surfaces such as textured surfaces, curved surfaces, and soft-touch painted surfaces: Please use the included double-sided tape (JIS "Super Strong" tape, manufactured by 3M). Dome section: Polyurethane resin (non-yellowing) Pattern markings: Hairline laser printing Adhesive: Strong adhesive