NEMA23 Electric Motor 2‑Phase 56 Stepper 1.8 degrees 1.5Nm Stepping Driver Replacement Tools

Feature: 1. Imported high‑quality motor steel sheets, bearings made of German technology, low self‑inductance, good responsiveness. 2. The front and rear covers are perfectly connected, the body is black electrophoresis, high‑end atmosphere, and the body size is standard. 3. The inner rotor adopts German technology, and the surface is coated with imported rotor glue to prevent burrs on the surface after carbon steel oxidation and grinding, resulting in increased motor noise. 4. Imported high quality motor steel sheets, bearings made of German technology, low self inductance, good responsiveness, and can be directly connected to the load for low speed operation without gear reduction in the state of close to locked rotor. 5. The motor can quickly start and stop, frequently rotate CW CCW, and accurately control, the number of pulses determines the motor position. Specification: Item Type: Electric MotorMaterial: Carbon steel Purpose: Industrial motor control, transmission and transmission occasions Step Angle: 1.8 degrees Voltage: Determined by the equipped driver, no fixed voltage Current: 3.0A Holding Torsion: 1.5N.m Resistance: 1.5 Ohm Inductance: 3.5mH phase Length: Approx. 76mm 3inSize: Approx. 7.5mm 0.3in Number of Outlets: 4 Shaft Type: Milling single flat table Step Angle Accuracy: + 5percent (full step) Resistance Accuracy: + 10percent (20 celsius ) Inductance Accuracy: + 20percent (1KHZ) Temperature Rise: 80 celsius maximum (rated current, 2 phase energization) Ambient Temperature: 20 celsius +50 celsius Insulation Resistance: 100M Ohm Min, 500VDC Withstand Voltage: 500VAC for one minute Radial Clearance: 0.02mm maximum (450g load) Axial Clearance: 0.08mm maximum (450g load) Maximum Radial Load: 75N (20mm from flange surface) Maximum Axial Load: 15N. Package List: 1 x Electric Motor Note: 1. When connecting the motor to the driver, do not connect the wrong phase.2. Due to different driving conditions, the motor may have obvious heat generation. The surface temperature of the motor is not allowed to exceed 85 degrees C during operation.3. When installing the motor, be sure to use the front end cover of the motor for positioning, and pay attention to tolerances to ensure the concentricity of the motor shaft and the load.